from 600 to 1 650 lm
We can specify any luminosity for our light fixtures (within maximum and minimum limits). Specific indicator depends on the Customer's requirements for illumination.
We can fine-tune the output by finding the best ratio between the lm/W value (from 140 and above), the light fixture lifetime (about 100,000 hours), and the light comfort.
Color temperature (CCT)
We can specify any color temperature: from warm white color used mostly at home or in offices, to cold white color, which is more common in the industry.
36 В -50 Гц
In our light fixtures power supplies are tuned to the specified power, which increases its efficiency by 3-10%. In standard solutions, the efficiency is sharply reduced when nominal power values are not respected.
Power supply location
The location of the power supply can be of any configuration, depending on the specific needs of the light fixture installation, the installation surface and its operating conditions.
High power factor of our light fixtures ensures the electrical efficiency.
Without reflectors and optics
Some models of our light fixtures can be equipped with reflectors to direct the required light as desired. For example, reflectors are used in the light fixtures installed at significant altitudes (8-10 m and higher), which directs light downward.
We use only the most advanced LEDs, since we create light fixtures for particular projects, and do not warehouse them. Generally, our solutions are 5-10% more effective than competitors due to more advanced LEDs.
Housing and radiator are produced of aluminum, which increases the efficiency of LEDs by 10-15%, and extends the service life by 30-50% as compared to steel or polymer housings. And the use of aluminum mounting plate instead of textolite one allows to increase the efficiency of LEDs by 3-5% and extend the service life by 10-20%.
Light diffusing polycarbonate
Our cover has light transmission efficiency of 92-93%. In standard solutions, the efficiency of light scattering materials is 80- 82%. We do not use open LEDs, transparent plafonds or lens solutions that can cause light discomfort to our consumers.
Possible choice of length
The length of the light fixture is specified by its power, luminous flux, expected service life, as well as temperature operating modes.
Lighting parts in all of our light fixtures have the maximum ingress protection rating – IP65, even if the allowed ingress protection rating is lower. We guarantee the cleanness of the cover throughout the service life of the item. The loss of luminous flux in LED lighting fixtures with dust-proof covers will be 10-20% after 3 years of operation.
from -25 to +60 °C
We develop light fixtures for operations even in extreme temperature conditions. This is relevant for street lighting, lighting of iron and steel enterprises, etc.
Optionally - Cricket, DALI, 3-level
We developed our own Cricket control system, which is much cheaper than systems developed by competitors, and allows us to save up to 30% of total power consumption. This system can be configured for 3 modes of operation (maximum, medium, minimum) or programmed for motion sensors, presence sensors, light sensors, time of day and certain dates.
Full guarantee for 5 years with the possibility of extension for another 5 years.